Fabric Sewing Equipment Roll

A fabric roll-up case to put your sewing equipment, keeping it safe for transport and storing! Can be made to store other equipment such as paintbrushes, crayons, makeup brushes or stationary!

Step 1

Mark out a 50cm x 50cm square on your choice of outer and lining fabric. Cut out.

To mark out you can use pins, make a pattern from paper or use tailors chalk (always do this on wrong side of fabric).

Step 2

Lay outer fabric square right side up onto fusible interfacing (shiny side up), pin and cut out. Carefully fuse interfacing to outer fabric with a warm iron (too hot can melt the interfacing). Make sure wrong side of fabric is facing shiny side of interfacing.

Step 3

Lay lining fabric on outer fabric, right sides together. Pin edges, marking a 20-30cm gap down one side (this is required to turn the fabric through the right way). Sew the squares together with a 1cm seam allowance, make sure to not sew over gap you marked out.

Step 4

Clip all 4 corners close to, but not through, the stitching line. Turn fabric right way around, through the gap from step 3. Gently smooth corners out fully, and iron the seams flat, making sure to fold the open gap in evenly as you iron it.

Step 5

Once caddy has been ironed flat, sew a topstitch approx. 5mm from the edge, all the way around (this will close the gap used to turn fabric through in step 4).

Step 6

With lining facing up, fold 1/3 (approx 16cm) of the caddy square up. Pin in place, and sew sides down, using the topstitch line as a guide.

Step 7

Lay out the equipment to be stored in the caddy, allowing space for items to fit properly. Using pins, mark out around the items where the stitching lines will go to make the separate pockets. For shorter items, also mark along the bottom of the pockets. Carefully sew along marked stitch lines.

Step 8

Measure and cut ribbon into lengths required to tie items such as scissors in place, then pin into place where required. Also cut and pin ribbon for outside tie on caddy (approx 30cm). Sew ribbon in place using vertical stitches and backtracking to hold firm.

Now place your sewing equipment in its new home, rollup, tie the ribbon, and off you go!!